Nordson's Adhesives & Sealants Guide - 2020-2021 (13th Edition)

13-48 | Controls
LogiComm OEM Applicator Driver
Specifications
Item
Ambient temperature range
Power supply high voltage
Power supply low voltage
Enclosure rating
Driver electrical output capacity
(current-controlling peak followed by a
reduced holding level)
Driver operational modes
Specification
0–50 °C (32–122 °F)
110–240 VAC (fuse-protected), max. 450 W depending on the load
20–28 VDC, 5 W
IP20
Each output:
1 electrical applicator at full performance
2 electrical applicators in series at reduced performance
Bead: The driver electrical output corresponds to the input trigger signal
Dot: The input trigger signal activates the driver electrical output for a programmable,
fixed time (0.05–4.95 ms)
Trigger input
Opto-isolated by driver, PNP
Trigger level
18–30 VDC
Number of channels 4
Diagnostic LEDs
Diagnostic LEDs per channel
Fault output
Ready output
Programming
Terminal block connections
Mounting
Dimensions
POWER 230 VAC
POWER 24 VDC
ENABLE
FAULT (short circuit/open circuit)
TRIGGER
OUTPUT
FAULT (short circuit/open circuit)
DOT MODE/PURGE
Potential-free contact rated at 0.25 A @ 24 VDC, opens on output fault (open circuit,
short circuit, or thermal)
Potential-free contact rated at 0.25 A @ 24 VDC, closes on unit ready
Programming of the driver is accomplished by connecting a USB Type-B PC interface
cable to a port on the driver and using the supplied service software (CD).
Quick-disconnect
DIN rail, 35 mm
178 mm x 105 mm x 73 mm
7.01 in. x 4.13 in. x 2.87 in.
Driver Software Parameter Ranges
Parameter Description Range
Peak current Target current level for initial peak 0.0–3.0 A
Hold current Target current level for hold 0.0–1.5 A
Time Time for initial peak 0.6–2.0 ms
To place your order, NAD call 1-888-NORDSON (1-888-667-3766), fax 1-770-497-3733 or online at www.enordson.com.
International Orders, call 1-440-985-4797, fax 1-440-985-1096, or email intcustomerservice@nordson.com