Nordson's Adhesives & Sealants Guide - 2020-2021 (13th Edition)

Adhesive & Sealants Equipment Guide
Web Content
Controls | 13-47
LogiComm OEM Applicator Driver
Description
The LogiComm® OEM applicator driver is a highperformance,
four-trigger, four-output channel electric
applicator driver that easily installs in an OEM control
cabinet to interface with a PLC. The driver comes
programmed with settings for the e.dot® series electric
applicator but can be reprogrammed via a computer to
drive many other hot melt or liquid adhesive electric
applicators.
LogiComm OEM applicator drivers support
communication to the PLC via the digital I/O. The
customer can reset the driver to a fault condition or
enable the driver. Additionally, a driver contact is
opened upon a fault such as an open or short coil or a
thermal fault.
LogiComm OEM Applicator Driver
Features
• Program driver settings via computer
• Four trigger inputs and four output channels
• Small driver size, DIN rail mounting and two-piece
plug type connectors facilitate installation in an OEM
control cabinet
• Each output can be:
– Programmed to drive different applicator types
– Tested independently via a purge button or a signal
from a PLC
• Two trigger modes are available: normal/bead and dot
• Four status LEDs for trigger, output, dot mode and
fault (short and open coil detection)
• Fully programmable to support current and future
Nordson applicators
• Fully serviceable
• USB connection:
– Allows field software upgrades
– Allows uploading of new settings through software
– Allows ability to back up settings
• Digital I/O:
– Enable/disable driver or reset the driver from a fault
condition
– Fault contact opened if an open/short coil is
detected or a thermal fault
To place your order, NAD call 1-888-NORDSON (1-888-667-3766), fax 1-770-497-3733 or online at www.enordson.com.
International Orders, call 1-440-985-4797, fax 1-440-985-1096, or email intcustomerservice@nordson.com