Nordson's Adhesives & Sealants Guide - 2020-2021 (13th Edition)

13-44 | Controls
LogiComm Applicator Driver
Specifications
Item
Applicator outputs
Applicator series supported
Applicator drivers
Independent triggers
Trigger levels
Dot mode time range
Manual purge/test
Alarm output contact
Display type
Specification
4 or 8 channel
All Nordson electric applicators including: E3xx, E400, E700, EM100, EM900, e.dot, LA82x,
LA9xx and WM8xx
80 W maximum per 4 channel driver (160 W total)
4 opto-isolated (NPN or PNP; source or sink)
10–30 VDC
0.05–12.75 mSec
Purge or flush; either mode available with “hammering”
1 form C potential-free contact; “Failsafe” design; Active when OK; Inactive when fault, power off
or disconnected
Contact rating: 0.5 A at 250 VAC
Backlit LCD graphic
Maximum power requirement 200 W (2 A)
Electrical service
Ambient temperature range
Approvals and certifications
Environmental
Mounting
Dimensions (approx.)
170–264 VAC typical; 50/60 Hz; 1 phase
90–132 VAC and 170–200 VAC at reduced applicator performance
0–50 °C (32–122 °F)
UL and CE
Terminal Block version : IPX4
Connector version: IP30
Cast mounting feet with 2 holes (top) and 2 slots (bottom)
330 mm (width) x 305 mm (height) x 178 mm (depth)
12 in. (width) x 12 in. (height) x 7 in. (depth)
To place your order, NAD call 1-888-NORDSON (1-888-667-3766), fax 1-770-497-3733 or online at www.enordson.com.
International Orders, call 1-440-985-4797, fax 1-440-985-1096, or email intcustomerservice@nordson.com