Nordson's Adhesives & Sealants Guide - 2020-2021 (13th Edition)

Adhesive & Sealants Equipment Guide
Web Content
Controls | 13-43
LogiComm Applicator Driver
Description
The LogiComm® Applicator Driver is a high
performance electric applicator driver for either hot
melt or liquid adhesive applications that supports all
Nordson Adhesives electric applicators, eliminating the
need for different drivers for different applicators. It
has four trigger inputs to interface to a pattern control,
PLC or other device. The driver is available in four
or eight channel models, each with either convenient
external quick disconnect connectors or with traditional
terminal blocks where IPX4 water protection is needed.
Each output is independently programmable to respond
to any trigger input and can control a different type of
applicator on each channel. The LogiComm applicator
driver makes set-up a snap. The user only needs to
select the applicator type from menu and the correct
pre-defined settings for that applicator are loaded
automatically. The flexible design also allows the driver
to be programmed with customized applicator output
settings.
Set-up and troubleshooting are aided by LED indicators
as well as sophisticated diagnostics. In addition an alarm
signal can be sent to a remote device such as a PLC.
Future driver firmware upgrades are performed via the
internal USB port.
Features
• Four- and eight-channel models available
• Two I/O connection styles:
– Quick-disconnect electrical connectors speed
installation and maintenance
– Internal two–piece terminal blocks provide water
protection and preserve wiring labor in the event of
a unit change
• Each output can:
– Select which trigger input to respond to
– Be enabled or disabled for product changes
– Drive a different type of applicator
– Be activated using the purge button for testing,
purging or flushing
LogiComm Applicator Driver
• Fully programmable to support future Nordson
applicators and competitive applicators
• Two trigger modes: normal/bead and dot (fixed time
duration)
• Operator panel displays status as well as simplifying
installation and setup
• Self-diagnostics coupled with the display and
indicators simplify troubleshooting
• Status indicators: eight outputs, four triggers, power,
alarm and fault
• USB connection for firmware upgrades and to save/
restore settings (electrically isolated from internal
power circuitry)
• Internal 24 VDC power supply eliminates the
need for a separate power supply for EPC pattern
controller
• Input line filter helps withstand high levels of noise,
permitting reliable operation in industrial and factory
environments
• Hinged enclosure simplifies internal access when
required
• AC power switch for convenience
To place your order, NAD call 1-888-NORDSON (1-888-667-3766), fax 1-770-497-3733 or online at www.enordson.com.
International Orders, call 1-440-985-4797, fax 1-440-985-1096, or email intcustomerservice@nordson.com