Nordson's Adhesives & Sealants Guide - 2020-2021 (13th Edition)

13-42 | Controls
EcoBead E Applicator Driver
Specifications
Item
Ambient temperature range
Power supply high voltage
Enclosure rating
Driver electrical output capacity
(current-controlling peak followed
by a reduced holding level)
Driver bead modes
Trigger input
Trigger level
Number of channels 2
Diagnostic LEDs
Diagnostic LEDs per channel
Output
Inputs
Configuration
Connections
Mounting
Dimensions (W x H x D)
Specification
0–50°C (32–122°F)
110–240 VAC (fuse- protected), maximum 450 W depending on the load
IP40
Each Output:
1 electrical applicator at full performance
2 electrical applicators in series at reduced performance
Dot/Gap, Dot/Savings, Stitch, Solid
Opto-isolated by driver, PNP
18–30 VDC
Power / System Status
Trigger, Output/Status
NPN output that is active while the system is powered and running properly (100 mA
maximum current)
Three configurable inputs that can be used for channel enable/disable or purge
All configuration and diagnostics done through Wi-Fi enabled PC or handheld smart
device
All connections are with M-type connectors
DIN rail, 35 mm
152.4 mm x 108 mm x 44.45 mm (6 in. x 4.25 in. x 1.75 in.)
Driver Software Parameter Ranges
Parameter Description Range
Peak Current Target current level for initial peak 0.0–4.0 A
Hold Current Target current level for hold 0.0–2.0 A
Peak Time Time for initial peak 0.01–10.0 ms
Part Numbers
P/N
Description
1129000 Kit, EcoBead E driver (includes I/O, power, and input cables)
1128998 Cable, EcoBead E I/O (included in P/N 1129000)
1128997 Cable, EcoBead E to E-400 applicator
1128996 Cable, power, EcoBead E driver (included in P/N 1129000)
1100687 Cable, input, MiniBlue II applicator (two of these cables are included in P/N 1129000)
To place your order, NAD call 1-888-NORDSON (1-888-667-3766), fax 1-770-497-3733 or online at www.enordson.com.
International Orders, call 1-440-985-4797, fax 1-440-985-1096, or email intcustomerservice@nordson.com