Nordson's Adhesives & Sealants Guide - 2020-2021 (13th Edition)

Adhesive & Sealants Equipment Guide
Controls | 13-41
EcoBead E Applicator Driver
Electric Stitching Solution
Description
The EcoBead E is a high-performance, two-trigger,
two-output-channel electric applicator driver that
easily installs in a control cabinet to interface with a
PLC. The EcoBead E driver can also be programmed
to generate a pattern of dots or stitched beads to
deliver any desired level of adhesive savings. The driver
comes programmed with settings for the E400 series
electric applicator, but can be configured via Wi-Fi to
drive many other hot melt or liquid adhesive electric
applicators.
EcoBead E applicator drivers support communication
to the PLC via the digital I/O. The configurable inputs
can be used to purge or enable each channel or both
channels at once. The status of the EcoBead E driver is
communicated to a PLC through an NPN connection.
EcoBead E Applicator Driver
Features
• Program driver settings via Wi-Fi with any PC or smart
device
• Two trigger inputs and two output channels
• Small driver size, DIN rail mounting, and
connectorized cabling facilitate installation in OEM
control cabinet
• Each output can be:
– Programmed to drive different applicator types
– Tested independently via purge button or a signal
from a PLC or a Wi-Fi enabled PC or handheld
smart device
• Four bead modes available: Dot/Gap, Dot/Savings,
Stitch, and Solid
• LEDs indicate triggers, outputs, and system status at a
glance
• Fully configurable to support current and future
Nordson applicators
• Wi-Fi connection:
– Allows field software upgrades
– Allows easy, no-touch configuration
– Allows ability to back up settings
EcoBead E Programming
Interface on the Web
• Digital I/O:
– Enable/disable output or reset the driver from a
fault condition or purge
– Fault indicated via NPN connection if an open/
short coil or a thermal fault is detected
To place your order, NAD call 1-888-NORDSON (1-888-667-3766), fax 1-770-497-3733 or online at www.enordson.com.
International Orders, call 1-440-985-4797, fax 1-440-985-1096, or email intcustomerservice@nordson.com