Nordson's Adhesives & Sealants Guide - 2020-2021 (13th Edition)

9-22 | Hand-Held Applicators
Series FP-200 Hand-Held Applicators
Specifications
Item
Pattern type (1)
FP-200 standard
FP-200 reduced cavity
FP-200 CF
FP-200 CF-WP
Specification
Bead
Bead
Swirl
Wide swirl
Operating temperature
230 °C (450 °F) maximum
Working hydraulic pressure MPa (psi) 10.34 (1,500) maximum
Air pressure (2) MPa (psi)
FP-200 standard and reduced cavity
0.21–0.42 (30–60)
FP-200 CF swirl and wide pattern 0.27–0.48 (40–70)
Air consumption
3.2 scfm maximum
Spray pattern width (3) mm (in.)
FP-200 CF
6–38 (0.25–1.5)
FP-200 CF-WP 25–152 (1–6)
Nozzle orifice diameters (4) mm (in.)
FP-200 standard
0.203–0.61 (0.008–0.024)
FP-200 extended extrusion 0.64–4.75 (0.025–0.187)
FP-200 reduced cavity 0.20–0.51 (0.008–0.020)
FP-200 CF swirl 0.20–1.27 ( 0.008–0.050)
FP-200 CF swirl, wide pattern 0.64–1.17 (0.025–0.046)
Electrical service
220–240 VAC, 50/60 Hz
(1)
FP-200 hand-held applicators are compatible with most Nordson applicators, both RTD and thermostatic-based technology.
(2)
Recommended range. Dry, regulated, unlubricated air required for consistent hand-held applicator operation. Module performance
and durability will be negatively affected if operated outside the recommended range. Volumetric air requirements will vary with handheld
applicator configuration and application.
(3)
Maximum achievable swirl pattern width depends on adhesive being dispensed.
(4)
Order nozzles separately on standard extrusion hand-held applicators. For reduced cavity modules, specify nozzle diameter with
hand-held applicator purchase as nozzle is an integral component of RC modules.
To place your order, NAD call 1-888-NORDSON (1-888-667-3766), fax 1-770-497-3733 or online at www.enordson.com.
International Orders, call 1-440-985-4797, fax 1-440-985-1096, or email intcustomerservice@nordson.com