Nordson's Adhesives & Sealants Guide - 2020-2021 (13th Edition)

7-58 | Automatic Applicators
E-400BR Electric Applicators
Specifications
Item Specification Note
Coil electrical service 380 VDC, 2 A peak, 0.4 A hold Operating voltage of the coil
Heater electrical service 240 VAC, 50/60 Hz Operating voltage of the heater
Heater wattage Varies Refer to the identification plate
Opening time
Closing time
Cycle time
2–3 ms
2–3 ms
4–6 ms
Time required for the valve to fully open; this time is
adhesive-dependent
Time required for the valve to de-energize and fully
close; this time is adhesive-dependent
Shortest total time the valve requires to fully open and
close; this time is adhesive-dependent
Cycle rate Up to 300 Hz Cycles per second; adhesive-dependent
Maximum hydraulic pressure Up to 103 bar (1500 psi) Maximum rated pressure
Maximum working pressure 82.7 bar (1200 psi) Maximum pressure at which module can actuate
Recommended viscosity range
Operating temperature
Applicator mounting
800–1200 mPas
Up to 190 °C (375 °F)
12 mm or 1/2" hex/round stock
Adhesive viscosity outside the recommended range
may result in splashing, slower cycle times, and/or
increased stringing
Operating over 190 °C (375 °F) may result in
premature failure
To place your order, NAD call 1-888-NORDSON (1-888-667-3766), fax 1-770-497-3733 or online at www.enordson.com.
International Orders, call 1-440-985-4797, fax 1-440-985-1096, or email intcustomerservice@nordson.com