Nordson's Adhesives & Sealants Guide - 2020-2021 (13th Edition)

3-2 | Bulk Melters
VersaDrum
200-liter or 55-gallon Drum Melters
Specifications
Item
Type of system
Drum diameter
(Drum volume)
Maximum pump rate (1)
Platen surface
Number of hose/applicator pairs
Maximum working hydraulic pressure
Operating temperature range
Ambient temperature range
Temperature control stability
Temperature sensor
Electrical service (2)
Maximum system power capacity
Weight (empty) (3)
Protection
Approvals
Options
Specification
Gear pumps with variable speed AC motors
571 mm (22.5 in) or [Japan only 567 mm (22.3 in)]
(200 liter / 55 gallon)
270 kg/hour (595 lb/hr)
Finned (high melt), axial, or smooth
2 standard (hydraulic & electrical)
Up to 6 additional (electrical only)
100 bar (1500 psi)
200 bar (3000 psi) — HP piston pump only
40–230 °C (100–450 °F)
-5–40 °C (23–100 °F)
±1 °C (2 °F)
Ni120 (or PT-100 optional)
200 VAC 3 phase delta 50/60 Hz
240 VAC 3 phase delta 50/60 Hz
400 VAC 3 phase Y 50/60 Hz
400 VAC 3 phase delta 50/60 Hz
480 VAC 3 phase delta 50/60 Hz
575 VAC 3 phase delta 50/60 Hz
39 kW
672 kg (1482 lb)
IP54
CE
Output pressure control — flow control bypass or automatic pressure control
PROFIBUS-DP, PROFINET IO, ControlNet, or EtherNet/IP communication
6 additional temperature channels
Pump choices: Single-stream, dual-stream, hardened, or two pumps
Fiber drum jacket
Automatic or manual aeration system
Retractable drip shield
Exhaust hood
Warning light tower
Pallet load frame
(1)
Actual rates will vary depending on adhesive type, application parameters and input voltage.
(2)
Permitted deviation from rated line voltage is ±10%.
(3)
Weight depends on melter configuration.
PROFIBUS and PROFINET are registered trademarks of PROFIBUS & PROFINET International.
To place your order, NAD call 1-888-NORDSON (1-888-667-3766), fax 1-770-497-3733 or online at www.enordson.com.
International Orders, call 1-440-985-4797, fax 1-440-985-1096, or email intcustomerservice@nordson.com