Nordson's Adhesives & Sealants Guide - 2020-2021 (13th Edition)

2-4 | Foam Systems
Ultra FoamMix Processor Systems
General Specifications
• Compact, service-friendly design
• Siemens S7 PLC with intuitive touch panel for easy operation and displays of all process parameters in many local
languages
• Integrated control of VDK applicators and material supply system (when specified as complete system)
• Free selection of foam percentage from 0% (solid) up to 70% foam (gas ratio) depending on material
• Foam unit for the generation of fine pored foam and higher foam ratios
• Permanent sensor failure monitoring with visual display
• Dry output contacts for Alarm and Ready signal
• 0–10 Volt interface for external pump control
• Week/Day timer (PLC)
• Start-up pressure control
• Choice of temperature sensor PT100, Ni120
• Ethernet connection for remote diagnostics and service
Siemens is a registered trademark of Siemens AG.
Ultra FoamMix Specifications
NOTE: These specifications apply to the special stand-alone foam processor system.
Item
Specification*
Foam station pump sizes (1)
Up to 18.9 liters/hour
up to 30.2 liters/hour
up to 54.6 liters/hour
up to 126 liters/hour
up to 210 liters/hour
Gas injection
Nitrogen or plant air (low pressure)
Electrical service (2)
3x 400 VAC + N + PE
Max. adhesive pressure
100 bar (1450 psi)
Max. operating temperature
250 °C (478 °F)
Temperature sensors
PT100 / Ni-120/ Fe-CuNi
Hose connections
8, 13, 16, 20 mm
No. of material outlets 1 or 2
*This is a generic specification. Exact specifications of Engineered Systems are valid with order confirmation only.
(1)
Maximum output rate depends on material and foam rate.
(2)
Transformer may be needed for any other local power supply.
To place your order, NAD call 1-888-NORDSON (1-888-667-3766), fax 1-770-497-3733 or online at www.enordson.com.
International Orders, call 1-440-985-4797, fax 1-440-985-1096, or email intcustomerservice@nordson.com