Rust-Oleum Undercoating - Menards
Rust-Oleum Undercoating - Menards
Rust-Oleum Undercoating - Menards
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Rust</strong>-<strong>Oleum</strong> ® <strong>Undercoating</strong><br />
DESCRIPTION A black rubberized, paintable protective coating.<br />
USES For preventing rust on bare or primed metal, including the underbody and wheel<br />
wells of cars, trucks, trailers and other recreational vehicles.<br />
APPEARANCE Dries to a flat-black, rubberized finish.<br />
SURFACE PREPARATION (See directions on can for more details)<br />
Remove all rust, dirt, oil and grease from the surfaces to be coated so that the<br />
surface is clean and dry. Mask off the area to avoid overspray on the auto finish.<br />
The use of a <strong>Rust</strong>-<strong>Oleum</strong> ® Primer will provide additional adhesion and hiding and<br />
is especially recommended for bare metal.<br />
MIXING Shake can vigorously for one minute after mixing ball begins to rattle. Shake the<br />
can often during use.<br />
APPLICATION Use outdoors or in a well-ventilated area such as an open garage. Use when air<br />
temperature is between 50°F (10°C) and 90°F (32°C) and humidity is below 85%<br />
to ensure proper drying. Avoid spraying in very windy, dusty conditions. Cover the<br />
surrounding area to protect from spray mist. Hold the can 12-16" from the surface<br />
and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep<br />
the can the same distance from the surface. Keep the can in motion while spraying.<br />
Remove any overspray from the auto finish immediately. For best results, apply a<br />
second coat 1-2 minutes after applying the first coat. Allow to dry for a minimum of<br />
one hour.
PHYSICAL PROPERTIES (Calculated values, may vary slightly from the actual manufactured material)<br />
RESIN TYPE<br />
SOLVENT TYPE:<br />
VOC (Volatile Organic Compounds)<br />
WEIGHT PER GALLON<br />
WEIGHT PER LITER<br />
SOLIDS BY WEIGHT<br />
SOLIDS BY VOLUME<br />
RECOMMENDED DRY FILM THICKNESS PER COAT<br />
WE T FILM TO ACHIEVE DFT<br />
Modified Rubber<br />
Aromatic/aliphatic hydrocarbon<br />
NA<br />
NA<br />
NA<br />
52.0%<br />
NA<br />
2.0 – 4.0 mil<br />
4.0 – 8.0 mil<br />
PRACTICAL COVERAGE @ RECOMMENDED DFT 5 – 10 square feet<br />
APPLICATION CONDITIONS See above<br />
DRY TIMES @70° - 80°F (21° - 27° C) AND 50%RH 1 – 2 hours tack-free<br />
SHELF LIFE 3 Years<br />
SAFETY (For additional information, see MSDS)<br />
FLASHPOINT -156F<br />
LEAD-FREE
Change language