Quickstart – BACS Installation Safety instructions - Generex GmbH

Optional REV 3 : You can order an external temperature sensor for the REV 3. This one will be mounted as
the REV 2 as follows.
REV 2 : This type of C Module hat its temperature sensor on a 10cm cable which has to be placed on the
battery surface. Detach the foil at the temperature sensor and place the sensor nearby the housing of the
accumulator (not on cooling fins nor closing plugs). Please note, that the surface is clean to assure an
accurate attachment of the sensor.
Note: Never mix different BACS C modules ! Eg. REV 2 must not be used with REV 3 on the same battery
system.
The supply and measuring
cable connected to a BACS C
module
BACS C module fixed with velcro
strip on a accumulator
Figure 3: Assembling and Connection of the Module
All modules should be connected together via the BACS RJ10 bus-cables (Part No. B2BCRJ10xxx) using
the 2 sockets at the back of the BACS module. Connect with these bus-cables all the modules in series (any
socket of the BACS module can be used, it does not matter if left or right socket). The last cable has to be
connected to the BACS BUS CONVERTER or to the BACS WEBMANAGER Input. It is not required to built
up a ring, so the last BACS module may be connected only with one cable.
Copyright of the European Union is effecti ve (Copyright EU) (c) 2012 GENEREX Systems GmbH, H amburg, Ger many, All rights reserved
TEL +49( 40)22692910 - EMAIL gener ex@generex.de - WEB www.generex.de (This and all other product datasheets ar e available for downl oad.)