User´s Manual - I+ME ACTIA GmbH

Export Read Data by ID
The diagnostic service Read Data by Identifier allows to read the content of pre-defined ECU data
referenced by a Data Identifier (DID) (e.g.: the VIN Vehicle Identification Number). The Diagnostic
Output window allows reviewing the diagnostic buffer content including an interpretation of these data.
To store this data activate the window below by using the assigned Session Menu item.
Note: The command Export Read Data by ID gets enabled when the first response frame - containing
the first part of the ECU data – is in the first line of the buffer review window Diagnostic Output. (In
this case, this frame is displayed in the status bar too.)
Tip: Use the Find it feature to find the first response frame ( 3 rd data byte must be 5A).
The default settings of CAT propose to store the logged content as data.s1a (Service 1A file) using the
s#[CAT internal session number] folder as destination folder.
The user is free to change name and destination according to the PC system and used operating system.
There will be a warning if the file name already exists asking if it shall be overwritten.
Experienced user may manipulate the stored data. (See Diagnostic Data by ID Edit for details.)
The stored data can be imported again when using the diagnostic service Write Data by Identifier .
73