User´s Manual - I+ME ACTIA GmbH

Being Diagnostic Offline
In general the Diagnostic Offline Mode is identical to the Offline Mode. The only difference is that
Signal List, Frame List or Trace List View are not available but the Diagnostic Output window can be
opened.
Choose menu item Commands | Diagnostic Offline to go Diagnostic Offline. See Changing CAT
Modes for details and how to leave the Diagnostic Offline Mode. Being in Diagnostic Offline Mode it is
possible to analyze logged diagnostic data or to do the same settings as being Offline:
Analyzing:
To visualize the diagnostic relevant bus traffic, the Diagnostic Output window and the Status Bar can be
used.
Choose menu item Windows | Diagnostic View to open/ close the window.
Note: After being Online you have to upload the Buffer before you have access to the logged data.
Otherwise you still see the buffer data that has been uploaded before.
See Offline Analyzing | Buffer Handling for details.
Setup Analyzer windows
The Frame and Signal List Views display in On- and Offline mode only the Frames and Signals that
have been selected to be displayed.
Choose menu item Configurations | Frame (Signal) List to select Frames (Signals) you want to display.
See chapter Layout Setup | Frame List (Signal List ) for details.
Setup Application Layout
To adopt the Layout of CAT windows application to the different PC platforms and customer needs
CAT provides the possibility to change the size of character fonts and the column width of the Views.
Choose menu item Layout | to modify the settings.
See chapter Layout Setup | View Layout Settings for details.
Setup CAN
CAT supports normal "Dual Wire" CAN and additionally the Single Wire CAN. For easy Setup of CAT
to the CAN bus, there are already three physical layers predefined: Single Wire CAN, Dual Wire CAN
(Mid Speed) and Dual Wire CAN (High Speed).
Choose menu item Configurations | CAN Setup of the main window to open the CAN Setup window
and to adjust the Baud Rates of the physical layers.
See chapter System Setup | CAN Setup for details.
Maintain Databases:
The databases are structured in a strict hierarchical order. A Database contains Vehicles that contain
ECU's that send Frames that carry Signals.
Choose menu item Configurations | to create, edit or remove the elements of a
database.
See Database Maintaining for details.
Configure Filter:
Up to 10 Pass Through Filter can be configured to filter the bus traffic that is logged and displayed.
Choose menu item Configurations | Filter List to open the Filter List and define the conditions.
See Configurations | Filter List for details.
Configure Trigger Conditions:
CAT allows defining a Trigger Event based on Frame Identifier and Data. This Trigger is used to set a
mark into the logged buffer and to stop the logging of data.
Choose menu item Configurations | Trigger to setup the Trigger Conditions.
See chapter Configurations | Trigger for details.
52