User´s Manual - I+ME ACTIA GmbH

LED Interpretation
Normal States:
1) Power-On = red.
Default after hardware reset.
2) Firmware-Download = green.
The 1st part of the firmware loader switches the LED to green.
3) Normal operation OFFLINE = blinking 2 times: red, green, pause.
Normally it blinks 2 times, that means all is ok.
The 1st blink shows the OFFLINE state = red or the ONLINE state = green.
4) Normal operation ONLINE = blinking 2 times: green, green, pause.
Normally it blinks 2 times, that means all is ok.
The 1st blink shows the OFFLINE state = red or the ONLINE state = green.
5) Block-transfer errors while receiving commands on the RS232
= blinking 4 times: red|green, green, green, green, pause.
The RS232 reception module has detected problems with the RS232-block-transfer and waits for a transfer
pause to reinitialize his buffers.
6) Normal operation (after RS232-errors) = blinking 3 times: red|green, green, green, pause.
After detecting RS232-block-transfer-errors and buffer re-initialization it is back to normal operation. It
never goes back to blinking 2 times.
Special States:
7) Firmware-Initialization = red for 20ms, green for 20ms.
The short red-green makes CAT-firmware in the first part of the initialization. It shows that the firmware
now starts.
8) Internal error
Any other blink code indicates an internal error.
In this case please note the blink code you see and send a short description about this to I+ME ACTIA.
To: info@ime-actia.de
I+ME ACTIA appreciates support.
45