User´s Manual - I+ME ACTIA GmbH

Upload Information Window
The Upload Information window starts automatically when activating the buffer upload. This might be
done by sing the command Upload buffer or the Hot Key F8. The buffer upload could also be activated
automatically by the Trigger . When uploading the buffer the content is transmitted from CAT
Hardware to the PC.
The green bar symbolizes the status of the upload of the logging buffer and the yellow bar symbolizes
the status of the upload of the diagnostic buffer
Different to the Download Information window the buffer Upload window shown below allows the
access to the application when open.
Do NOT wait when uploading.
If the information window shown above displaying the status of the buffer upload process is open, shift
it to the side and click into the window you want to use.
Although the Upload process is not finished it is possible to jump to the end of the buffer (using the End
key). CAT will load immediately the required data. So there is no need to wait for the finish of the
upload.
42