User´s Manual - I+ME ACTIA GmbH

Find It
CAT provides a search command to allow the user easily to find certain frames in the buffer. Using the
different possible Views in Offline respectively Diagnostic Offline, the user can open the dialog box
shown below by activating Commands | Find It ...
Define the search criteria as described below and press the Find Next button to start the search. Press
the button again to find the next buffer entry that fulfils the done description.
Note: If no next entry fits to the defined frame, you will be asked if you want to continue the search
at the top / bottom of the buffer (depending on search direction).
ID
Input the CAN ID of the frame you are looking for. (Here $641: ID of Diagnostic Response to a request
with ID $241.)
Note: Let input field blank to search independent of the CAN ID.
Format
Input the CAN Format of the frame you are looking for. (STD for standard 11bit ID and XTD for
extended 29 bit ID)
Data
Input the Data Bytes as hexadecimal values of the frame you are looking for. (Here 3 rd Byte = 5A:
Indicating a positive respond to a diagnostic service $1A request Read Data by ID.)
Note: Let any of the 8 input fields blank to search independent this field.
Direction
Depending on the current location in the buffer you can select if you search for the specified frame
Down: checking the following frames starting with the most recently received frame after the actual
positioned frame,
or Up: checking the preliminary frames starting with the most recently received frame before the actual
positioned one.
Find Next
Press this button to start searching the frame according to the defined description and setup for the
search algorithm.
Cancel
Press Cancel to re-do the inputs that have been done and to close the window.
184