User´s Manual - I+ME ACTIA GmbH
User´s Manual - I+ME ACTIA GmbH
User´s Manual - I+ME ACTIA GmbH
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Launch Service Diagnostic Online<br />
Choose menu item Commands | Diagnostics to open the Online Diagnostic Launch dialog as shown<br />
below. As an Online Control window there is no need to close the window to work on. Just shift it aside<br />
to have a free view on the main application and shift it back when it is needed again.<br />
This dialog allows launching a diagnostic service in accordance to the settings that have been done<br />
offline before. See Diagnostics for details about the setup of the Main Diagnostic Launch Table and so<br />
the Online Diagnostic Launch dialog.<br />
Click on the launch button to transmit the displayed service. If periodic transmission of the service is<br />
adjusted the Launch button turns into a Stop button.<br />
Press the Stop button to stop the transmission. The Stop button turns back into a Launch button.<br />
Note: All diagnostic services are sent out as USDT (Unacknowledged Segmented Data Transfer)<br />
requests.<br />
Note: The filter has no influence on the transmission of frames by CAT including the launch of<br />
diagnostic services.<br />
Note: When going diagnostic online the Online Diagnostic Launch window is opened automatically.<br />
According to GMLAN the following services require a tester present service. For these services the box<br />
under "Tester Present" on the left side of the dialog should be marked if not otherwise required for<br />
testing purposes.<br />
- ($AA) Read Data by Packet Identifier,<br />
- ($AE) Device Control.<br />
- ($27) Security Access,<br />
- ($10) Initiate Diagnostic Operation,<br />
- ($28) Disable Normal Communication,<br />
CAT sends out the tester present service automatically just before the wished service and then every 2<br />
seconds (may vary, depending on the bus traffic) when Tester Present box has been marked before in<br />
Offline or Diagnostic Offline mode.<br />
The tester present service is sent until either the Service Return to Normal Mode is sent or when<br />
changing into Offline respectively Diagnostic Offline Mode.<br />
177