User´s Manual - I+ME ACTIA GmbH

Launch Diagnostic Services
Choose menu item Commands | Diagnostics to open the Main Diagnostic Launch Table shown below.
As an Online Control window there is no need to close the window to work on. Just shift the table aside
to have a free view on the main application and shift it back when it is needed again.
This Table allows launching the services in accordance to the settings that have been done offline
before. See Diagnostics for details about the setup of the Main Diagnostic Launch Table.
Note: The configuration / setup of the Main Diagnostic Launch Table is even possible when being
online already by opening the Main Diagnostic Setup dialog under Configurations.
To transmit a CAN Frame representing a service, the service has to be selected first in the list and then
the launch button has to be clicked.
Note: All diagnostic services are sent out as USDT (Unacknowledged Segmented Data Transfer)
requests.
Note: The filter has no influence on the transmission of frames by CAT including the launch of
diagnostic services.
According to GMLAN the following services require a tester present service. For these services the
boxes in the Tester Present column on the left side of the dialog are marked by a *.
- - ($AA) Read Data by Packet Identifier,
- - ($AE) Device Control.
- - ($27) Security Access,
- - ($10) Initiate Diagnostic Operation,
- - ($28) Disable Normal Communication,
172