User´s Manual - I+ME ACTIA GmbH

Transmitting
CAT allows defining 10 different Transmit Frames based on Frame Identifier and Data. The Transmit
Frames that shall be used have to be defined in Offline mode. Also the Transmission Frames are
assigned to a hot key CTRL 0 – 9 in Offline mode. (See Transmit List and Transmit Definition for more
details.)
The Transmission of the frame can be activated and deactivated only in online mode one by one. The
activation of the transmission of all or groups of the defined Transmission Frames at once is not
possible.
Note: The filter has no influence on the transmission of frames by CAT including the launch of
diagnostic services.
To activate the Transmission of a Frame
By Hot key
Use the assigned hot key combination to transmit the frame. Depending on the defined transmit
conditions the frame will be transmitted once (one shot) or periodically until you deactivate the
transmission.
By Transmit Table
Choose menu item Commands | Transmit to open the Transmit Table shown below. Select a defined
frame by clicking into the list. The Send button gets enabled. Click the Send button to transmit the
frame. Depending on the defined transmit conditions the frame will be transmitted once (one shot) or
periodically until you deactivate the transmission.
Close the table or shift it to the side if it is blocking the view to the Frame or Signal List.
Note: None defined filter has any influence on the transmission of Frames by CAT.
The Transmit Table
The first column describes the hot key the frames are assigned to. The Name of this frame is shown in the next
column. The defined periodic transmission rate respectively 'one shot' is figured out in the last column
To deactivate the Transmission of a Frame
By Hot key
Use the assigned hot key combination to stop the transmission of the frame.
By Transmit Table
169