User´s Manual - I+ME ACTIA GmbH

needs to select a mask. By click on Select Mask the dialog shown below appears or the user may put in
directly a one-byte hexadecimal value that defines the mask.
Note: The send-on-change status mask and DTC count information are lost upon a $3E time-out,
after a $20 service request, or after power is cycled.
The DTC Status Mask contains 8 DTC status bits. To check for a logical '1', a set bit the user has to
mark it in the list. In the sample above all bits are marked so the DTC Status Mask hexadecimal value is
a 'FF'.
Warning Indicator Requested State
Warning output status reports the status of any warning indicators associated with a particular DTC.
Warning outputs may consist of indicator lamp(s), displayed text information, etc.
- Logical '1' = Warning indicator requested to be ON.
- Logical '0' = Warning indicator not requested to be ON.
Current DTC Since Power Up
This indicates that a DTC became current during the current ignition/power cycle.
- Logical '1' = DTC became current this power up.
- Logical '0' = DTC did not become current this power up.
Test Not Passed Since Current Power Up
This indicates a logical '0' once the test indicates a passed result. A logical '1' indicates that the test has
not run, or that the test has run and failed.
- Logical '1' = Test not passed since current power up.
- Logical '0' = Test passed since current power up.
Note: This flag is reset to a logical '1' with each ignition cycle.
131