User´s Manual - I+ME ACTIA GmbH
User´s Manual - I+ME ACTIA GmbH
User´s Manual - I+ME ACTIA GmbH
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Read Trouble Codes<br />
This service ($A9) allows a tester to read the status of node-resident Diagnostic Trouble Code (DTC)<br />
information from any controller, or group of controllers within a vehicle. This service allows the tester<br />
to do the following:<br />
- Retrieve the status of a specific DTC and FaultType combination.<br />
- Retrieve the list of DTCs that match a tester defined DTC status mask.<br />
- Enable a node resident algorithm, which periodically calculates the number of DTCs that match a tester<br />
defined DTC status mask. The ECU shall send a response message each time the calculation yields a<br />
different result than the one calculated the previous time.<br />
Depending on the required action the service has to be configured. Therefor the Setup button in the<br />
Main Diagnostic Setup window could activate the dialog box shown below.<br />
$80 Read Status Of DTC By DTC Number<br />
To retrieve the status of a specific DTC and DTC Fault Type Byte (symptom) combination, setup the<br />
sub-parameter $80 Read Status Of DTC By DTC Number. The user needs to put in the DTC number<br />
(DTC High Byte and DTC Low Byte) and the DTC Failure Type Byte. Acknowledge the settings by<br />
OK.<br />
$81 Read Status Of DTC By Status Mask<br />
To retrieve a list of DTC numbers and DTC Fault Types, which satisfy the defined status mask, setup<br />
the sub-parameter byte $81 Read Status Of DTC By Status Mask. The user needs to select a mask. By<br />
click on Select Mask the user opens the dialog shown below or the user may put in directly a one-byte<br />
hexadecimal value that defines the mask.<br />
Note: CAT uses the End Of DTC Report message to determine when all UUDT responses to a level<br />
$81 request have been sent. For a given node, transmitting another $Level $81 request prior to receiving<br />
the endOfDTCReport message may result in undefined operation.<br />
$82 Send On Change DTC Count<br />
To enable a node-resident DTC count algorithm that periodically calculates the number of DTCs that<br />
match a defined DTC status mask, setup the sub-parameter $82 Send On Change DTC Count. The user<br />
130