User´s Manual - I+ME ACTIA GmbH

Note: This field is only enabled if periodic is chosen as type of transmission.
Format: Choose standard (STD 11bit Identifier) or extended (XTD 29bit Identifier) format.
Note: This field is given if you choose a predefined frame.
Number
of Data Bytes: Select the number of data bytes of the frame.
RTR: Enable the RTR = Remote Transmission Request field to define a RTR frame. Note that this is a
frame that includes the data length information but no data bytes.
High Voltage: This must be enabled if a frame shall be send as a "High Voltage Wakeup Frame" on the Single-
Wire-CAN. If the user has selected one of the other physical CAN drivers this functionality is ignored.
Identifier: Insert the Identifier on Bit level of the Frame that shall be transmitted. Click directly into the boxes
showing the binary values of the ID Bits. The value changes with each click, from 0 to 1.
Note: Is given if the user chooses a predefined frame.
Identifier HEX: Insert the Identifier on Hex level of the Frame that shall be transmitted.
Note: Is given if the user chooses a predefined frame.
Data Byte 0 – 7: Insert Data Bytes on Bit level that shall be transmitted. Click directly in the boxes showing the
binary values of the Data Bits. The value changes by each click, from 0 to 1.
Note: Is given if the user chooses a predefined frame.
Data Byte HEX: Insert Data Bytes on the Hex level that shall be transmitted.
Click on OK to acknowledge the input.
122
Note: Is given if the user chooses a predefined frame.