User´s Manual - I+ME ACTIA GmbH

Transmit Definition
After choosing a Transmit frame in the Transmit List and clicking the Assign button the user reaches
the Transmit Definition window shown below. Here the frame and conditions for transmitting can be
setup.
If frames shall be transmitted that are already defined in the "car" system that shall be analyzed, the user
can select a frame here by choosing the assigned ECU and then the frame. The frame ID, format,
number of data bytes and the default data will be implemented automatically. Then the user will only
have to define the type of transmission and in case of periodic transmission the rate. Nevertheless the
user can modify the automatic implemented frame corresponding values.
Key: Shows the hot key that is assigned to this Transmission frame. Depends on the line that has been
chosen in the Transmit List.
Database: Shows the database the user is working with. Only predefined frames from this database can be
chosen.
Vehicle: Shows the vehicle the user is working with. Only predefined frames from this vehicle can be
chosen.
ECU: Here the ECU that the predefined frame is assigned to can be chosen.
Frame: Here a predefined frame of the database can be chosen.
Otherwise or even if the user has chosen a predefined frame one can edit another name for the transmission frame.
These can be:
a) the name of a predefined frame that has been chosen from the database by selecting the ECU before.
b) the edited name of a predefined frame. E.g. when the assigned data have been edited too.
c) a new name that shall be used for the new defined transmission frame.
In any case the name in this field will be shown as Transmission Name in the Transmission List.
Note: Editing a frame or defining a new frame here has no influence on the Frames
listed in the database!
Type: Choose Periodic or One Shot type of transmission.
Periodic Rate [ms]: Input an integer value for the transmission rate in ms.
121