User´s Manual - I+ME ACTIA GmbH

Filter List
CAT allows defining 10 different "Pass Through" Filter based on Frame Identifier and Data.
The Filter List ... shown below is used as an access to the Filter Definition window and to enable
already defined Filter.
Note: After Defining and Enabling the Filter have to be activated. See Filtering for details about
activating and deactivating.
Note: The filter has no influence on the transmission of frames by CAT including the launch of
diagnostic services.
Choose menu item Configurations | Filter from the main window to open the Filter List... window
shown above.
Enable
To enable already defined filter click right into the box below the text Enable: in the horizontal line to
the Filter you want to enable.
Note: Enabling more than one Filter will combine the pass through conditions of all that are selected.
(E.g. Filter #1 pass through all frames with CAN IDs between $000 and $7FF and Filter #2 all between
$800 and $8FF. Enable Filter #1 and #2 means all frames with CAN IDs between $000 and $8FF will
pass through.)
Assign/Edit
Click in the Filter List to choose an already defined Filter or to choose the line to be assigned to a new
filter.
Note: Choosing a line from the Filter List will enabled the Assign/Edit button.
Click on Assign/Edit to open the Filter Definition window, which allows setup the filter condition.
Delete
Click in the Filter List to choose an already defined Filter to be deleted
Note: Choosing an existing Filter will enable the Delete Button.
Click on Delete to erase the chosen Filter and all assigned data. There will be no warning before the
filter is removed from the table.
116