TITAN TTL530GBC PETROL MULTI TOOL 61145

Fig.29
4. To replace the spool simply remove from the spool assembly and replace with a new one of
the same type that recommended.
5. To replace the line take out the spool and remove the remaining cutting line.
6. Cut a new 3m long cutting line with a diameter of 2.4mm. Form a loop at the middle of the
line and insert this loop into the hook on the spool(Fig.30).
Fig.30
7. Wind the two parts of the cutting line in clockwise direction firmly around the spool each part
in the guide on the spool(Fig.31).
Fig.31
8. Insert each end of the threads in the respective holes. The threads should stick out 150 mm
on each side.
9. Screw the bumper anti-clockwise until it is completely and safely locked.
43CC PETROL BRUSH CUTTER TTL530GBC