TITAN TTL530GBC PETROL MULTI TOOL 61145
TITAN TTL530GBC PETROL MULTI TOOL USER MANUAL TITAN TTL530GBC PETROL MULTI TOOL USER MANUAL
3. Plunge the blade from above when cutting rank growth and undergrowth. 4. Move the blade close over the ground to cut young trees or grass. Fig.21 TRIMMING 1. Use the trimmer head and trimming guard to cut small weeds, grass or similar soft vegetation. 2. Hold the product with sufficient distance to your body. 3. Pay attention to your posture. Stand upright, do not lean forward. 4. Hold the trimmer head just above the ground at an angle of about 30°(Fig.23). 5. Move the product with slow and regular horizontal movements from the right to the left and then lead it back to starting point before trimming the next row(Fig.22). Fig.22 Fig.23 6. Clean the cutting means regularly. Stop the engine, switch the petrol brush cutter off and unplug the spark plug connector before checking. 7. Trim in steps when the grass is very high. Do not cut the total height in once(Fig.24).
Fig.24 TIPS 1. For best results, do not cut wet grass because it tends to stick to the cutting means and guard, prevents proper discharge of grass clippings, and could cause you to slip and fall. 2. Pay special attention when performing the work close to trees and bushes. The cutting means can damage sensitive bark, and damage fence posts(Fig.25). Fig.25 43CC PETROL BRUSH CUTTER TTL530GBC
- Page 1 and 2: 1 SAFETY AND OPERATING MANUAL Origi
- Page 3 and 4: SAFETY INSTRUCTIONS Warnings! Read
- Page 5 and 6: 11. Stop using the product while pe
- Page 7 and 8: 2. Stop the engine and unplug the s
- Page 9 and 10: Health Surveillance. All employees
- Page 11 and 12: Risk of fire / flammable materials
- Page 13 and 14: A 15 1 13 13a 19 14 20 18 17 22 3 2
- Page 15 and 16: A. Main unit 1. Engine 2. Upper sha
- Page 17 and 18: ACCESSORIES Torx screw driver (T25)
- Page 19 and 20: 2. Assembling shaft. 1). Align the
- Page 21 and 22: Ensure that there are no open flame
- Page 23 and 24: Operation instruction WARNING! For
- Page 25: STOPPING ENGINE WARNING! The cuttin
- Page 29 and 30: AIR FILTER 1. Inspect the air filte
- Page 31 and 32: Fig.29 4. To replace the spool simp
- Page 33 and 34: Troubleshooting Problem Possible ca
Fig.24<br />
TIPS<br />
1. For best results, do not cut wet grass because it tends to stick to the cutting means and<br />
guard, prevents proper discharge of grass clippings, and could cause you to slip and fall.<br />
2. Pay special attention when performing the work close to trees and bushes. The cutting<br />
means can damage sensitive bark, and damage fence posts(Fig.25).<br />
Fig.25<br />
43CC <strong>PETROL</strong> BRUSH CUTTER <strong>TTL530GBC</strong>