TITAN TTL530GBC PETROL MULTI TOOL 61145

6. Let the petrol brush cutter run in idle speed for 10-15s to let it warm up.
7.Depress throttle interlock (21) and then depress throttle trigger (24) to get full engine speed
for operation.
STARTING WARM ENGINE
1. Set ignition switch(22) to “I” position(Fig.15).
2. Move choke lever to “WARM START” position, do not depress primer bulb.
3.Depress throttle interlock(21) and then depress throttle trigger(24), and press this throttle
safety button(23) to lock it in half-gas position of throttle trigger(24). Once the throttle safety
button(23) is located, then release throttle interlock(21) and throttle trigger(24)
synchronously(Fig.13).
22
Fig.15
21
23
24
Fig.18
4. Pull the recoil starter to start engine. Now, your brush cutter is under idle-speed states.
5. Depress throttle interlock (21) and then depress throttle trigger (24) to get full engine speed
for operation.