TITAN TTL530GBC PETROL MULTI TOOL 61145

INTENED USE
WARNING! The petrol brush cutter must be fully assembled before operation! Do
not use a petrol brush cutter that is only partly assembled or assembled with
damaged parts. Always use gloves during assembly.
1. This petrol brush cutter is designated with a maximum power output of max. 1.4 kW.
2. With attached cutting guard and fitted cutting blade the petrol brush cutter is intended to cut
weeds, brush, small trees and similar vegetation with a thickness of up to 20 mm.
3. With attached trimming guard and fitted trimmer head the petrol brush cutter is intended to
be used to cut small weeds, grass or similar soft vegetation.
4. It may not be used to work on unusual thick, dry or wet grass, e. g. pasture grass, or to
shredder leaf.
5. For safety reasons it is essential to read the entire instruction manual before first operation
and observe all instructions.
6. This petrol brush cutter is for private use only, not for any commercial applications. It may
not be used for any purposes other than described.
Assembly instructions
Assembling the U-handle tube
1). Loosen the bolt and nut of the “U” shape tube(5),and Insert the main handle to the end of
the “U” shape tube(5), Tighten the bolt and nut at last(Fig.1).
2). Loosen the bolt and take the cover away from the connecting of handle(6).
3). Strained the throttle cable(4) with the cable ties.
4). Put the “U” handle tube into the slot on the connecting, chosen the suitable hole of
the “U” shape tube to the place where make your operation easier(Fig.2).Insert the pin into the
hole of the “U” shape tube.
5). Put the cover to the connecting of handle. Tighten the bolt of two sides with 5mm hex
key(38).
5 4
38
6
Fig.1 Fig.2 Fig.3