ES721 ISO40 7 kW NL - HSD

HSD
The tool holder is not
locked:
The tool holder is not
ejected:
There is no air pressure
inside the electrospindle:
One of the sensors does
not give the required
output:
There is dirt or foreign bodies
between the tool holder and the
spindle shaft housing
The tool holder cone is not of
the right type
There is insufficient air pressure
to open the collet
Sensor S2 is disconnected or
faulty
There is insufficient air pressure
There is insufficient air pressure
or the compressed air system is
faulty
A sensor is disconnected or
faulty
Remove any large foreign bodies
and clean the tool holder cone
and spindle housing as instructed
in section § 11.
Choose a tool holder as
instructed in section § 10.
� Check the air pressure
settings in accordance with
section 8.1 ;
� Check the compressed air
system for leaks and pressure
losses.
� Check the sensor connectors.
� Check the sensor cables for
breaks.
� Contact the HSD technical
assistance service.
� Check the air pressure
settings in accordance with
paragraph 8.1 ;
� Check the compressed air
system for leaks and pressure
losses.
� Check the air pressure
settings in accordance with
sections 8.1 ;
� Check the compressed air
system for leaks and pressure
losses;
� Contact the HSD Technical
Assistance Service.
� Check the sensor connectors;
� Check the sensor cables for
breaks;
� Contact the HSD technical
assistance service.
5801H0066 en Rev.01 45/48