OS-9 for the Prospector P1100 Board Guide

Transferring the ROM Image to the Target
The following procedures describe transferring the OS-9 ROM image from
the host system to the target system.
Note
An optional first step is to reset the baud rate on both the host and
target systems. At the target’s boot Monitor> prompt, type
b . For example b 57600 sets the
Prospector’s baud rate to 57,600 Bits per second. Change the
designated baud rate in your terminal emulation program. Make sure
the two settings match. Your maximum download rate will depend on
your terminal emulation program.
Step 1. Burn the image into the Prospectors application Flash.
Type l (“L”) at the boot Monitor> prompt. The firmware will then delete
the first entry in its application Flash and will then be ready to accept the
OS-9 ROM image.
You will be prompted to type Cntr+C when your S-record (the OS-9 ROM
image) is finished downloading.
Step 2. From the host system terminal emulation program, select the
appropriate function to enable downloading of raw ASCII files to your
connected serial port. In most emulation programs there is a menu
selection called “send file”.
Step 3. Navigate to the following directory in the emulation program’s interface:
MWOS\OS9000\ARMV4\PORTS\PROSPECTOR\BOOTS\INSTALL\PORTBOOT\
Select the file rom.S and send it to the target.
22 OS-9 for the Prospector P1100 Board Guide