OS-9 for the Prospector P1100 Board Guide
OS-9 for the Prospector P1100 Board Guide
OS-9 for the Prospector P1100 Board Guide
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Configure <strong>Board</strong> Switch Settings<br />
There is one switch setting to change <strong>for</strong> <strong>the</strong> <strong>Prospector</strong>/<strong>P1100</strong> to run<br />
<strong>OS</strong>-9. It is DIL switch SW5, shown in Figure 1-3. Figure 1-3 shows <strong>the</strong> DIL<br />
switch settings in <strong>the</strong>ir default positions. Leave <strong>the</strong> switches in <strong>the</strong>ir default<br />
positions until after you have burned <strong>the</strong> <strong>OS</strong>-9 ROM Image into Flash<br />
memory. After <strong>the</strong> <strong>OS</strong>-9 ROM image is in <strong>the</strong> <strong>Prospector</strong>’s Flash, change<br />
<strong>the</strong> SW5 switch to <strong>the</strong> High position, as shown in Figure 1-4.<br />
Figure 1-3 Default Switch Settings<br />
1 2 3 4<br />
5<br />
Figure 1-4 SW5 Switch Setting After Installing <strong>OS</strong>-9 ROM Image<br />
1 2 3 4<br />
5<br />
Creating <strong>the</strong> <strong>OS</strong>-9 ROM image and burning it into <strong>the</strong> <strong>Prospector</strong>’s Flash<br />
memory is described in <strong>the</strong> following sections of this manual.<br />
Note<br />
For detailed in<strong>for</strong>mation about setting switches, refer to <strong>the</strong> ARM<br />
<strong>Prospector</strong>/<strong>P1100</strong> User <strong>Guide</strong> supplied by ARM Limited. This manual<br />
can be downloaded from www.arm.com.<br />
12 <strong>OS</strong>-9 <strong>for</strong> <strong>the</strong> <strong>Prospector</strong> <strong>P1100</strong> <strong>Board</strong> <strong>Guide</strong>