Romeo 25 & Romeo Pro 50 - Enabling Technologies

Restore Menus to Factory Defaults
OL Takes the embosser off-line
0.0E Go to the Service Menu
95E Restore the factory default settings
1E Reset the embosser
Multi-Copy
Reminder: Stay on-line while using Multi-Copy.
3.0E Start Multi-Copy
3.1E Document is fully copied and ready to print
4.NNE Print "NN" (2 to 99) copies of the document
3.2E Stop printing at end of current copy
3.3E Cancel Multi-Copy
3.4E Suspend Multi-Copy at top of next sheet
3.5E Resume Multi-Copy following 3.4E
ET Speaks (Romeo Pro 50)
Two keys control ET Speaks when the embosser is ON-LINE.
The LF key makes ET Speaks repeat its last phrase
The FF key makes ET Speaks "shut up" in mid-phrase
ET Speaks tells you the current setting of menu parameters if you enter V.NE
while in the menu.
Single Sheet Mode (Romeo Pro 50)
Reminder: Translate document to 22 lines per page.
Place the first sheet of paper on the tractor rollers. Turn on the embosser.
Change the following settings in whatever menu you are using:
17.22E Set the number of lines per page to 22
11.1E Turn on perf skip
1.1E Exit menu and reset embosser
Also on the embosser's keypad, set top-of-form:
OL Takes the embosser off-line
2E Set top-of-form and return on-line
Romeo 25 & Romeo Pro 50 30