SL16352 Malco AutoBody Tools Catalog 2015
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
DENT REMOVAL SYSTEM & METAL WORKING TOOLS<br />
PNEUMATIC DENT REMOVAL<br />
& PUSH-TO-PAINT REPAIR<br />
Fast, air-actuated solution for controlled<br />
dent removal and push-to-paint repair.<br />
This unique rapid dent removal system<br />
offers adjustable air power to vary the<br />
speed and intensity of the pick action<br />
to quietly and effectively work out dents<br />
with minimum arm, wrist and hand strain.<br />
Use the RADiTAP to access dents via<br />
door and gate latch openings, through<br />
trunk and engine compartments, from<br />
wheel wells and more.<br />
RDR<br />
This innovative system<br />
compliments the skills of the<br />
dent specialist and reduces<br />
costs for the repair tech!<br />
MINIMUM REQUIREMENTS:<br />
2600 SPM • 4 CFM,<br />
133 L/Min 90 PSI, 6.2 Bar<br />
RDR1<br />
RDR2<br />
RDR5<br />
RDR8<br />
6 mm<br />
6 mm<br />
11 mm<br />
4 mm<br />
RDR3 RDR6 RDR4 RDR7<br />
19 mm 11 mm 18 x 15 mm 6 mm<br />
A total of 8 pick and tip head configurations, plus 3<br />
interchangeable 18, 36 and 48-inch (46, 91 and 122 mm)<br />
drive shaft rods allow multiple set-up combinations to achieve<br />
the best fit for the dent removal task at hand.<br />
Adjustable air valve varies the<br />
speed and intensity of pick action<br />
to quietly work out dents.<br />
PUNCH & FLANGE<br />
AIR TOOL<br />
Versatile 2-in-1 design reduces metal<br />
fabrication time by half.<br />
One tool makes both holes and flanges in 22 to 16-gauge<br />
(0.76 to 1.52 mm) automotive grade, mild steel to accommodate<br />
clean, no-bump lap welds.<br />
Use one side of the tool head to punch a clean, flat, burr-free 5/16<br />
inch (8 mm) diameter hole. Use the other side of the tool head to<br />
form a 7/16 inch (11 mm) long, 1 inch (25.4 mm) wide and .040 inch<br />
(1 mm) deep offset flange. The head also rotates for ease of use.<br />
Every pull of the motor lever delivers a single stroke punch or flange<br />
crimp with precision control.<br />
AIR REQUIREMENTS:<br />
4 CFM, 133 L/Min – 90 PSI, 6.2 Bar<br />
PF1 EV<br />
13