05.07.2017 Views

Mercedes-Benz-W212-instrukcja-obslugi

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Engine compartment 311<br />

dipstick is (depending on the engine)<br />

approximately 1.6 to 2.1 US qt. (1.5 to 2 l).<br />

! Do not add too much oil. If the oil level is<br />

above the MAX mark on the dipstick, too<br />

much oil has been added. This can lead to<br />

damage to the engine or the catalytic<br />

converter. Have excess oil siphoned off.<br />

Further information on engine oil<br />

(Y page 391).<br />

X Replace cap : on the filler neck and<br />

tighten clockwise.<br />

Ensure that the cap locks into place<br />

securely.<br />

Checking and adding other service<br />

products<br />

Checking the coolant level<br />

Only check the coolant level when the vehicle<br />

is on a level surface and the engine has cooled<br />

down.<br />

X Turn the SmartKey to position<br />

2(Y page 149) in the ignition lock.<br />

On vehicles with KEYLESS-GO, press the<br />

Start/Stop button twice (Y page 150).<br />

X Check the coolant temperature display in<br />

the instrument cluster.<br />

The coolant temperature must be below<br />

158 ‡ (70 †).<br />

G Warning<br />

In order to avoid any potentially serious burns:<br />

Ruse extreme caution when opening the<br />

hood if there are any signs of steam or<br />

coolant leaking from the cooling system, or<br />

if the coolant temperature display indicates<br />

that the coolant is overheated.<br />

Rdo not remove the pressure cap on the<br />

coolant reservoir if the coolant temperature<br />

is above 158 ‡ (70 †). Allow the engine to<br />

cool down before removing the cap. The<br />

coolant reservoir contains hot fluid and is<br />

under pressure.<br />

Rusing a rag, slowly turn the cap<br />

approximately 1 / 2 turn to relieve excess<br />

pressure. If opened immediately, scalding<br />

hot fluid and steam will be blown out under<br />

pressure.<br />

Rdo not spill antifreeze on hot engine parts.<br />

Antifreeze contains ethylene glycol which<br />

may burn if it comes into contact with hot<br />

engine parts.<br />

X Slowly turn cap : half a turn counterclockwise<br />

and allow excess pressure to<br />

escape.<br />

X Turn cap : further counter-clockwise and<br />

remove it.<br />

If the coolant is at the level of marker bar<br />

= in the filler neck when cold, there is<br />

enough coolant in coolant expansion<br />

tank ;.<br />

If the coolant is approximately 0.6 in<br />

(1.5 cm) higher when warm, there is<br />

enough coolant in coolant expansion<br />

tank ;.<br />

X If necessary, add coolant which has been<br />

tested and approved by <strong>Mercedes</strong>-<strong>Benz</strong>.<br />

X Replace cap : and turn it clockwise as far<br />

as it will go.<br />

For further information on coolant, see<br />

(Y page 392).<br />

Maintenance and care<br />

Z

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!