FAIRMONT HOTELS & RESORTS -DESIGN STANDARDS
Hotel Design
Hotel Design
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>FAIRMONT</strong> <strong>HOTELS</strong> & <strong>RESORTS</strong> · <strong>DESIGN</strong> <strong>STANDARDS</strong><br />
PUBLIC AREAS<br />
3.12. Swimming Pools and Whirlpool<br />
Provide swimming pools and whirlpool facilities in relation to specific program<br />
requirements (consideration for outdoor pools to be determined in relation to project<br />
location/climate). The water purification system should be a chlorine automatic feed<br />
system with modular cartridge filters. It is essential that any vibration arising from the<br />
swimming pools and whirlpool mechanical equipment be not transmitted to the building<br />
structure.<br />
Combination of lap pool, wadding pool and whirlpool to be considered in relation to<br />
specific program requirements.<br />
Water surface to be (approximately 1,500 ft 2 – 140 m 2 ) (Resort 10,000 ft 2 – 930 m 2 )<br />
minimum or as required by the specific program requirements. Maximum pool depth to<br />
be 4’6” (1.4 m). The water temperature to be regulated to a maximum of 80F (27C).<br />
A separate pool area (Resorts) should be provided for children (approximately 800 ft 2 –<br />
74 m 2 ) with water level from 2’ 0” (0.6 m) to maximum of 3’ 0” (0.9 m) deep. The<br />
pool should incorporate an area for small children where the water is from 0’ 0” to 1’ 0”<br />
(0 to 0.3 m) deep. Locate children’s pool remote from main pool(s) to minimise<br />
disturbance of adult guests.<br />
Access must avoid circulation through the main lobby. The facilities must be adjacent to<br />
the spa/health club to share staff and locker facilities. Proximity to the guestroom<br />
elevator core is required. Access to sunny location and exterior view is important.<br />
Water Depths:<br />
At shallow end 3’ 0” (0.9 m)<br />
At main drain (1/3 of pool length from deep end) 4’6” (1.4 m)<br />
At deep end 4’ 0” (1.2 m)<br />
Whirlpool 2’ 10” (0.8 m)<br />
Plunge Pool 4’ 0” (1.2 m)<br />
The whirlpool (approximately 250 ft 2 – 23.2 m 2 ) should be exceptionally large and<br />
unusual in shape, preferably not circular. It will generally be recessed in the pool deck<br />
although the surrounding wall may be up to 2’ 0” (0.6 m) high, i.e., whirlpool recessed<br />
1’ 6” (0.5 m) into pool deck. The wall should be wide enough to permit comfortable<br />
seating on top. Maximum depth should be 3’6” (1.1m).<br />
The water temperature to be regulated to a maximum of 105F (40C).<br />
An additional 50% extra aerator outlets shall be installed in the whirlpool in addition to<br />
minimum quantity recommended by whirlpool equipment suppliers to provide a really<br />
lavish aeration system. These outlets should be mounted 6” and 12” (15 x 30 cm)<br />
above the seat. Whirlpool aeration control shall be by means of a 15-minute time switch<br />
located near the whirlpool at 5’ 0” (1.5 m) to centre line above finished floor level.<br />
REV. MARCH 2006 68<br />
© 2002, Fairmont Hotels and Resorts. All Rights Reserved.