FAIRMONT HOTELS & RESORTS -DESIGN STANDARDS

FAIRMONT HOTELS & RESORTS · DESIGN STANDARDS
GUESTROOM AREAS
Windows (continued)
2.11. Mechanical and Electrical
g) Where sliding louvered panels are used in lieu of drapes, a locking
device must be provided on the panels to maintain security when
exterior sliding doors are open.
a) Convectors and grilles with concealed fixings to be painted to
match adjacent surface. Ductwork behind grilles to be painted
matt black
b) Access to the control valves, fan motors and fan scrolls will be
through a 1’6” x 2’6” (0.5 x 0.8 m) return air grille
c) The horizontal fan coil unit is to be designed with a three speed
motor and sized so the unit will provide the required heating or
cooling output when the motor is running at slow speed. The unit
sound level is not to exceed NC30 at slow speed and NC35 at
medium speed. The valves, coils and thermostats must be silent in
operation. The fan coil unit motor must run continuously at the
selected speed and not cycle off when the desired temperature is
achieved
d) Energy smart thermostats to be mounted 54” (137 cm) to centre
line AFFL
e) Incorporate switch in frame of balcony door in humid climates to
close down FCU when door is opened for extended periods of
time
f) Electrical outlets in party walls to be offset by at least 1’0”
(0.3 m) to maintain specified sound ratings
g) Light switches to be mounted 48” (120 cm) to centre line AFFL
h) Electrical outlets to be mounted 1’0” (0.3 m) to centre line AFFL
i) Locate 2 plex outlets at desk as shown on Fairmont Hotels and
Resorts Design Standards Details
j) Install door bell to all suites and guestroom that have extra long
entry foyer
k) Surface mounted ceiling fixtures in entry foyer and bedroom
REV. MARCH 2006 116
© 2002, Fairmont Hotels and Resorts. All Rights Reserved.