FAIRMONT HOTELS & RESORTS -DESIGN STANDARDS

FAIRMONT HOTELS & RESORTS · DESIGN STANDARDS
CONSTRUCTION REQUIREMENTS
2. PRE-OPENING, OCCUPATION AND INSTALLATION REQUIREMENTS
2.1. General
The construction company is required to provide the following services:
a) Fairmont Hotels & Resorts will be permitted to occupy the building in
stages as it is completed for the purpose of installing the FF&E
The contractor will be responsible for providing Fairmont Hotels &
Resorts with the following services at no cost during the FF&E
installation program:
i) Heating, cooling and humidity control as required to protect the
FF&E
ii) Temporary Lighting
iii) Completely clean all areas of the building prior to hand over to
Fairmont Hotels & Resorts including interior and exterior glass,
all finishes, vacuuming all floors, polishing all mirrors, chrome,
plumbing fixtures, etc.
iv) Removing from a central point on each floor all packing cases,
boxes, wrapping, off-cuts, etc. brought into the building by
Fairmont Hotels & Resorts.
v) Exclusive use of at least two elevators during normal working
hours and exclusive use of at least three elevators outside these
hours including providing all necessary elevator operators.
b) All areas must be fully operational and completely free of deficiencies
when turned over to Fairmont Hotels & Resorts.
c) Where an area includes equipment, including specialty equipment
supplied and installed under an FF&E contract, all equipment must be
connected, tested, and fully operational when turned over to Fairmont
Hotels & Resorts, including:
i) Food and beverage equipment
ii) Laundry and valet equipment
iii) Computer equipment
iv) Telephone equipment
v) Garbage compaction equipment
The construction contractor is responsible for coordinating with the
specialty equipment contractors, and Fairmont Hotels & Resorts, to
ensure these requirements are met.
REV. MARCH 2006 - 4 -
© 2002, Fairmont Hotels and Resorts. All Rights Reserved.