238658923659
1. Pull on the string, gently but firmly with your fingers, bringing it directly above the fingerboard, as shown in Figure 16-6. 2. Tune the string up to pitch by turning the key. After each pull, the string will be flat (under pitch), so repeat the process of pulling the string with your fingers and tuning up with the tuning key until the string no longer goes flat after you pull on it. You may have to do this three or four times, but the whole procedure shouldn’t take more than a couple of minutes. Figure 16-6: Pulling on the string to stretch it out after it’s tuned up. 310 Part V: Gearing Up: Outfitting Your Arsenal Stringing an Electric Guitar An electric guitar uses lighter-gauge strings (than an acoustic guitar), which makes the strings easier to control when stringing. But these types of strings are stretchier, so tuning takes a little longer. Lighter, skinnier strings also provide more wraps around the post, so allow more string length for wrapping around the post. Also, electric guitars don’t use bridge pins like acoustics do, so restringing electric guitars focuses mostly on the tuning-post end of the guitar. The steps for changing the strings on an electric guitar can be a little different. TEAM LinG
- Page 604: Chapter 15: Choosing Your Amp and E
- Page 608: Chapter 15: Choosing Your Amp and E
- Page 612: Chapter 15: Choosing Your Amp and E
- Page 616: Chapter 15: Choosing Your Amp and E
- Page 620: Chapter 15: Choosing Your Amp and E
- Page 624: Chapter 15: Choosing Your Amp and E
- Page 628: Chapter 15: Choosing Your Amp and E
- Page 632: Chapter 15: Choosing Your Amp and E
- Page 636: Chapter 16 Changing Strings In This
- Page 640: Chapter 16: Changing Strings 303 Ac
- Page 644: Chapter 16: Changing Strings 305 be
- Page 648: Chapter 16: Changing Strings 307 Ta
- Page 652: Chapter 16: Changing Strings 309 Fi
- Page 658: 312 Part V: Gearing Up: Outfitting
- Page 662: 314 Part V: Gearing Up: Outfitting
- Page 666: In this part . . . The Part of Tens
- Page 670: 318 Part VI: The Part of Tens Elmor
- Page 674: 320 Part VI: The Part of Tens TEAM
- Page 678: 322 Part VI: The Part of Tens TEAM
- Page 682: 324 Part VI: The Part of Tens TEAM
- Page 686: 326 Part VI: The Part of Tens Blues
- Page 690: 328 Part VI: The Part of Tens Maste
- Page 694: In this part . . . The Appendixes p
- Page 698: The Elements of Music Notation Figu
- Page 702: 334 Part VII: Appendixes TEAM LinG
1. Pull on the string, gently but firmly with your fingers, bringing it<br />
directly above the fingerboard, as shown in Figure 16-6.<br />
2. Tune the string up to pitch by turning the key.<br />
After each pull, the string will be flat (under pitch), so repeat the<br />
process of pulling the string with your fingers and tuning up with the<br />
tuning key until the string no longer goes flat after you pull on it. You<br />
may have to do this three or four times, but the whole procedure<br />
shouldn’t take more than a couple of minutes.<br />
Figure 16-6:<br />
Pulling on<br />
the string to<br />
stretch it out<br />
after it’s<br />
tuned up.<br />
310 Part V: Gearing Up: Outfitting Your Arsenal Stringing an Electric Guitar<br />
An electric guitar uses lighter-gauge strings (than an acoustic guitar), which<br />
makes the strings easier to control when stringing. But these types of strings<br />
are stretchier, so tuning takes a little longer. Lighter, skinnier strings also provide<br />
more wraps around the post, so allow more string length for wrapping<br />
around the post. Also, electric guitars don’t use bridge pins like acoustics do, so<br />
restringing electric guitars focuses mostly on the tuning-post end of the guitar.<br />
The steps for changing the strings on an electric guitar can be a little different.<br />
TEAM LinG