Autodata - Diagnostic Trouble Codes Fault locations and probable causes - 2004 edition

Engine management
44014601480 1,611,711,812,O
Year: 1990-97
Engine code: B16F, BlBEP, BlBFP, BlBU, B20F
System: Fenix 38
Engine bay, LH
General information
Refer to the front of this manual for general test conditions,
terminology, detailed descriptions of wiring faults and a
general trouble shooter for electrical and mechanical faults.
0 Trouble codes are displayed by the LED on the data link
connector (DLC).
Accessing
Open data link connector (DLC) cover.
Insert system selector cable in socket 2 rn [I].
Switch ignition ON.
Press test button for 0,5 to 1 second 121.
Count LED flashes rn [3].
Note trouble codes. Compare with trouble code table.
Trouble codes consist of a sequence of three groups of
flashes H.
A 3 second pause separates each group H [A].
For example: Trouble code 223 displayed H.
Erasing
NOTE: Trouble codes must be accessed and faults rectified
before codes can be erased.
Open data link connector (DLC) cover.
Insert system selector cable in socket 2 rn [I].
Switch ignition ON.
Press test button for 5 seconds minimum [2].
Release button. Wait until LED illuminates rn [3].
Press test button for 5 seconds minimum.
Ensure trouble codes have been erased.
The ECM fault memory can also be erased by
disconnecting the battery.
WARNING: Disconnecting battery may erase memory from
electronic units (e.g. radio, clock).
[ 792 I,,,,,,,.,,,, /Autdata