05.02.2017 Views

Autodata - Diagnostic Trouble Codes Fault locations and probable causes - 2004 edition

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

I Year: 03\95-96<br />

I<br />

Engine code: 1E<br />

System:<br />

Bosch Digifant MP4.0<br />

Engine management<br />

General information<br />

Refer to the front of this manual for general test conditions,<br />

terminology, detailed descriptions of wiring faults <strong>and</strong> a<br />

general trouble shooter for electrical <strong>and</strong> mechanical faults.<br />

o Carry out road test for at least 5 minutes.<br />

0 Briefly fully depress throttle pedal to increase engine speed<br />

over 3000 rpm.<br />

0 Allow to idle for 5 minutes.<br />

Accessing <strong>and</strong> erasing<br />

The engine control module (ECM) fault memory can only be<br />

accessed <strong>and</strong> erased using diagnostic equipment<br />

connected to the data link connector (DLC).<br />

I<br />

Above fascia relay plate<br />

<strong>Trouble</strong> code identification<br />

Flash type<br />

4-digit<br />

0000<br />

<strong>Fault</strong> location<br />

End of test sequence<br />

1111 I Engine control module (ECM) I ECM<br />

Probable cause<br />

221 2 I Throttle position (TP) sensor I Wiring, poor connection, TP sensor<br />

2222<br />

2242<br />

Manifold absolute pressure (MAP) sensor<br />

Mixture adjustment resistor<br />

231 2 I Engine coolant temperature (ECT) sensor I Wiring, poor connection, ECT sensor<br />

2322 I Intake air temperature (IAT) sensor I Wiring, IAT sensor<br />

2341 I Heated oxygen sensor (H02S) - lambda control I ECM<br />

2342 I Heated oxygen sensor (H02S) 1 Wiring, H02S, heating inoperative, fuel level low<br />

lncorporated in ECM<br />

I<br />

4444 ( No fault found<br />

I<br />

-<br />

Hose connection(s), ECM<br />

Wiring, mixture adjustment resistor<br />

-<br />

type<br />

5-digit<br />

00000<br />

<strong>Fault</strong> location<br />

No fault found<br />

Probable cause<br />

00518 1 Throttle position (TP) sensor I Wiring, poor connection, TP sensor<br />

00519 I Manifold absolute pressure (MAP) sensor / Hose connection(s), ECM<br />

00522<br />

00523<br />

00525<br />

Engine coolant temperature (ECT) sensor<br />

Intake air temperature (IAT) sensor<br />

Heated oxygen sensor (H02S)<br />

00532 1 Engine control module (ECM) - supply voltage I Alternator, battery, wiring<br />

01087 1 Engine control module (ECM) - basic setting I Basic setting not completed<br />

65535<br />

Engine control module (ECM) - defective<br />

-<br />

Wiring, poor connection, ECT sensor<br />

Wiring, poor connection, IAT sensor<br />

Wiring, H02S, heating inoperative<br />

lncorporated In ECM.<br />

4<br />

ECM

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!