05.02.2017 Views

Autodata - Diagnostic Trouble Codes Fault locations and probable causes - 2004 edition

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

VOLKSWAGEN Model: GolfNento 1,4 (-07192) GolfNento 1,8 (-07193)<br />

Passat 1,8 (AAM -07194)<br />

Passat 1,8 (ABS -1 0193)<br />

Engine management<br />

Year: 1991-1994<br />

Engine code:<br />

System:<br />

AAM, ABD, ABS, AAU, AAV, RP<br />

Bosch Mono-Motronic MA1.2.2<br />

GolfNento - below heater controls<br />

Passat - centre console<br />

Operate switch for 4 seconds minimum.<br />

Release switch. Check that LED flashes<br />

NOTE: 45 pin ECM multi-plug.<br />

Count LED flashes. Note trouble code.<br />

Each trouble code consists of four groups of one to four<br />

General information<br />

flashes. - -<br />

Refer to the front of this manual for aeneral test conditions. A 215 pause separates each trouble group [A].<br />

terminology, detailed descriptions of\iring faults <strong>and</strong> a<br />

general trouble shooter for electrical <strong>and</strong> mechanical faults.<br />

<strong>Trouble</strong> codes are displayed by using an LED connected to<br />

one of the ECM terminals.<br />

The ECM fault memory can also be checked <strong>and</strong> erased<br />

using diagnostic equipment connected to the data link<br />

connector (DLC).<br />

Self-diagnosis using flash type trouble codes may not<br />

display all available diagnostic information.<br />

Carry out road test for at least 10 minutes.<br />

Ensure accelerator pedal is briefly fully depressed <strong>and</strong><br />

engine speed exceeds 3000 rpm.<br />

Accessing<br />

Ensure ignition switched OFF.<br />

Bridge black data link connector (DLC) terminal 1 rn [A] <strong>and</strong><br />

brown or white data link connector (DLC) terminal 1 rn [B]<br />

with a switched lead - contacts normally open.<br />

NOTE: Brown or white data link connector (DLC) terminal 1 is<br />

connected to ECM terminal 11.<br />

Connect LED test lamp between black data link connector<br />

(DLC) terminal 2 [A] <strong>and</strong> ECM terminal 4.<br />

ECM located in plenum chamber.<br />

NOTE: DO NOT disconnect ECM multi-plug as this will erase fault<br />

memory.<br />

Start engine. Allow to idle.<br />

NOTE: If engine does not start: Crank engine for 6 seconds.<br />

Leave ignition switched ON.<br />

Repeat switch operation. Note trouble codes. Compare with<br />

trouble code table.<br />

End of test sequence indicated by trouble code 0000<br />

(long flashes).<br />

Switch ignition OFF. Rectify faults as necessary.

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!