Autodata - Diagnostic Trouble Codes Fault locations and probable causes - 2004 edition

CarltonlOmega-8 2,012,512,613,O 24V
Senator-B 2,613,013,O 24V
Sintra 2,2 Frontera-A 2,012,2/2,4 Engine management1
General information
0 Refer to the front of this manual for general test conditions,
terminology, detailed descriptions of wiring faults and a
general trouble shooter for electrical and mechanical faults.
Trouble codes are displayed by the malfunction indicator
lamp (MIL).
0 The ECM fault memory can also be checked using
diagnostic equipment connected to the data link connector
(DLC).
Accessing
Ensure ignition switched OFF.
Except Omega-B: Bridge data link connector (DLC)
terminals A and B - 10-pin.
Omega-B: Bridge data link connector (DLC) terminals 6 and
earth - 16-pin.
NOTE: Models without a terminal in position 6 of the 16-pin DLC
do not display trouble codes using the MIL.
Switch ignition ON.
Trouble codes will be displayed after a short flash El [A] and
a long pause El [El.
Count MIL flashes. Note trouble codes. Compare with
trouble code table.
Each trouble code consists of two groups of one or more
flashes.
The first group of flashes indicate the 'tens' of the trouble
code El [Cl.
The second group of flashes indicate the 'units' of the
trouble code [Dl.
A short pause separates each trouble code group fl [El.
A long pause separates each trouble code El [F].
For example: Trouble code 12 displayed El.
Each trouble code including 12 displayed three times.
NOTE: Some models will display Trouble code 31 with the engine
off. Trouble code erased when the engine is running.
Erasing
NOTE: Some models 1992+ may require diagnostic equipment
to erase trouble codes.
Switch ignition OFF.
Disconnect battery earth lead for 60 seconds.
WARNING: Disconnecting battery may erase memory from
electronic units (e.g. radio, clock).
Repeat checking procedure to ensure no data remains in
ECM fault memory.
- a aEngine management 683
4