Autodata - Diagnostic Trouble Codes Fault locations and probable causes - 2004 edition

d$i
TEl(T) TSTC
NOTE: Engine control module (ECM) incorporates transmission
control function.
General information
Refer to the front of this manual for general test conditions,
terminology, detailed descriptions of wiring faults and a
general trouble shooter for electrical and mechanical faults.
Trouble codes are displayed by the 'OID OFF' warning lamp.
Accessing
Switch ignition ON.
Check operation of 'OlD OFF' lamp.
Switch the OID switch on the gear lever to ON.
Check that 'OID OFF' lamp extinguishes.
Bridge data link connector (DLC) terminals El and TEI.
+1996: El. I996 +: 0.
If no trouble codes are stored, the lamp will flash twice per
second O.
Each trouble code consists of two groups of one or more
flashes
[A].
Warning lamp flash duration: 0,5 second rn [B].
A 0,5 second pause separates each flash rn [C].
A 1,5 second pause separates each trouble code group rn [Dl.
A 2,5 second pause separates each trouble code [El.
For example: Four 0,5 second flashes - 1,5 second
pause - two 0,5 second flashes. Trouble code 42
displayed rn - vehicle speed sensor (VSS) 1.
Trouble codes are repeated 4,5 seconds after last trouble
code.
Count warning lamp flashes. Compare with trouble code
table.
Remove bridge wire.
Switch ignition OFF.
Rectify faults as necessary.