Autodata - Diagnostic Trouble Codes Fault locations and probable causes - 2004 edition

'
Model: Picnic 2,O Picnic 2,2D Turbo
Year: 1996-00
TOYOTA
Engine code:
System:
3C-TE, 3S-FE
TCCS
Engine management
Type 1 - engine bay, LH
I
L
Type 2 - under fascia, drfver's side
General information
0 Refer to the front of this manual for general test conditions,
terminology, detailed descriptions of wiring faults and a
general trouble shooter for electrical and mechanical faults.
Trouble codes are displayed by the malfunction indicator
lamp (MIL).
0 More detailed fault diagnosis information can be obtained
using diagnostic equipment connected to the data link
connector (DLC).
Accessing
Normal mode
Switch ignition ON.
Type 1: Bridge data link connector (DLC) terminals El and
TEI m.
Type 2: Bridge data link connector (DLC) terminals 4 and
13 0.
If no trouble codes are stored, the lamp will flash twice per
second Q.
Each trouble code consists of two groups of one or more
flashes rn [A].
Warning lamp flash duration: 0,5 second rn [B].
A 0,5 second pause separates each flash rn [C].
A 1,5 second pause separates each trouble code group rn [Dl.
A 2,5 second pause separates each trouble code rn [El.
For example: Two 0,5 second flashes - 1,5 second pause -
one 0,5 second flash. Trouble code 21 displayed -
heated oxygen sensor (H02S).
Trouble codes are repeated 4,5 seconds after last trouble
code.
Count MIL flashes. Note trouble codes. Compare with
trouble code table.
Remove bridge wire.
Switch ignition OFF.
Rectify faults as necessary.
A t a t a a
Engme management
8n
I
-