05.02.2017 Views

Autodata - Diagnostic Trouble Codes Fault locations and probable causes - 2004 edition

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Model: Carina E 1,6/1,8/2,0 Carina E 2,O<br />

Erasing<br />

MB C B ^ D MB 4E<br />

d<br />

NOTE: Fuse removal duration depends on ambient temperature.<br />

The lower the temperature the longer the fuse must be<br />

removed.<br />

Switch ignition OFF.<br />

Remove EFI fuse (15120A) from underbonnet fusebox for<br />

10 seconds minimum. 1,6/1,8: El [I]. 2,O: El [2].<br />

Refit fuse.<br />

<strong>Trouble</strong> codes may also be erased by disconnecting battery<br />

leads.<br />

WARNING: Disconnecting battery may erase memory from<br />

electronic units (e.g. radio, clock).<br />

Repeat checking procedure to ensure no data remains in<br />

ECM fault memory.<br />

Test mode<br />

Switch ignition OFF.<br />

Bridge data link connector (DLC) terminals El <strong>and</strong> TE2 0.<br />

Switch ignition ON.<br />

Ensure malfunction indicator lamp (MIL) flashes four times<br />

per second.<br />

Start engine.<br />

Drive vehicle at over 6 mph (10 kmlh).<br />

Stop vehicle. Do not switch ignition OFF.<br />

With data link connector (DLC) terminals El <strong>and</strong> TE2<br />

bridged, bridge terminals El <strong>and</strong> TEI 0.<br />

Count MIL flashes. Note trouble codes. Compare with<br />

trouble code table.<br />

Switch ignition OFF.<br />

Remove bridge wires.<br />

Rectify faults as necessary.<br />

NOTE: <strong>Codes</strong> 42 <strong>and</strong> 43 may be produced if this procedure is<br />

NOT carried out correctly. Code 51 will be produced<br />

during this procedure <strong>and</strong> can be ignored.<br />

<strong>Trouble</strong> code identification<br />

Flash type<br />

<strong>Fault</strong> b cdin<br />

Probable cause<br />

11111<br />

11<br />

12<br />

13<br />

14<br />

No fault faund<br />

Engine control module (ECM) - defective<br />

Crankshaft position (CKP) sensorlcamshaft<br />

position (CMP) sensor - no signal<br />

Crankshaft position (CKP) sensor - no signal<br />

over idle<br />

Ignition signal - no signal<br />

16 I Transmission control signal 1 Wiring, ECM<br />

18 I Supply voltage low/high I Wiring, battery, alternator, ECM<br />

2 1 I Heated oxygen sensor (H02S) I Wiring, H02S, ECM<br />

-<br />

ECM<br />

Wiring, CKPfCMP sensor, ECM<br />

Wiring, CKP sensor, ECM<br />

Wiring, ignition amplifier, ECM<br />

22 Engine coolant temperature (ECT) sensor - I Wiring, ECT sensor, ECM<br />

o~enlshort circuit<br />

24 I Intake air temperature (IAT) sensor - openfshort Wiring, IAT sensor, ECM<br />

circuit

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!