05.02.2017 Views

Autodata - Diagnostic Trouble Codes Fault locations and probable causes - 2004 edition

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Model:<br />

806 1,9D Turbo<br />

Erasing Method 2<br />

Ensure ignition switched OFF.<br />

Method 1<br />

Disconnect battery earth lead for 10 seconds.<br />

Switch ignition ON.<br />

Connect LED test lamp between data link connector (DLC)<br />

electronic units (e.g. radio, clock).<br />

terminal C3 <strong>and</strong> battery positive 0.<br />

Bridge data link connector (DLC) terminal C2 <strong>and</strong> earth with<br />

a switched lead - contacts normally open m.<br />

Operate switch for 2,5-5 seconds.<br />

LED or MIL will now flash trouble code 12.<br />

Repeat switch operation until code 11 is displayed.<br />

Operate switch for 10-20 seconds.<br />

Switch ignition OFF.<br />

WARNING: Disconnecting the battery may erase memory from<br />

<strong>Trouble</strong> code identification<br />

I<br />

Flash type 1 Fauit loeatton I Probable cause<br />

11<br />

12<br />

14<br />

16 1 Exhaust gas recirculation (EGR) solenoid 1 Wiring, relay module, EGR solenoid<br />

2 1 1 Fuel lever position sensor ( Wiring, fuel lever position sensor<br />

39<br />

41<br />

End of sequence<br />

Start of sequence<br />

Engine coolant temperature (ECf) sensor<br />

Malfunction indicator lamp (MIL)<br />

Crankshaft position (CKP) sensortengine speed (RPM)<br />

sensor<br />

46 I Fuel iniection pump - timinq control I Fuel injection pump timing<br />

I<br />

-<br />

-<br />

Wiring, ECT sensor, ECM<br />

49 I Fuel injection timing solenoid 1 Wiring, fuel injection timing solenoid<br />

53 I Battery voltage I Wiring, battery discharged, alternator<br />

Engine control module (ECM)<br />

Barometric pressure (BARO) sensor<br />

Gbw plug control module - pre-heat<br />

65 Injector needle lift sensor<br />

Wiring, MIL, ECM<br />

Wiring, CKPIRPM sensor, air gap, ECM<br />

Wiring, battery, ECM<br />

ECM<br />

- - --<br />

Wiring, glow plug(s), glow plug control module<br />

Wiring, fuel system, injector, injector needle lift<br />

sensor<br />

66 I Glow plug control module - pre-/post-heat I Wiring, glow plug control module<br />

67<br />

68<br />

Glow plug warning lamp<br />

Idle speed control (ISC) actuator<br />

Wiring, glow plug warning lamp, ECM<br />

Wiring, hoses blockedlleaking, ISC actuator<br />

4

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!