Chapter 8. Replacing FRUs - CNET Content Solutions
Chapter 8. Replacing FRUs - CNET Content Solutions Chapter 8. Replacing FRUs - CNET Content Solutions
80 Hardware Maintenance Manual POST Error Message Description/Action Press TAB to show POST screen Pressing the TAB key permits the user to toggle between the default POST display screen and a custom POST display screen. Error: Non-System disk or disk error Replace and press any key when ready The BIOS was unable to find a suitable boot device. Make sure the boot drive is properly connected to the computer. Make sure you have bootable media.
Miscellaneous error messages Message/Symptom FRU/Action Changing display colors Display/Monitor Computer will not power-off. See “Power 1. Power Switch Supply Problems” on page 55. 2. System Board 3. Riser card, if installed Computer will not RPL from server 1. Ensure that network is in startup sequence as first device or first device after diskette 2. Ensure that network adapter is enabled for RPL 3. Network adapter (Advise network administrator of new MAC address) Computer will not perform a Wake On LAN ® 1. Check power supply and signal cable (if applicable) connections to network adapter 2. Ensure that the operating system settings are set to enable Wake on LAN ® Dead computer. See “Power Supply Problems” on page 55. Diskette drive in-use light remains on or does not light when drive is active. Flashing cursor with an otherwise blank display. 3. Ensure Wake On LAN feature is enabled in Setup/Configuration (see “Starting the Setup Utility program” on page 51) 4. Ensure network administrator is using correct MAC address 5. Ensure no interrupt or I/O address conflicts 6. Network adapter (advise network administrator of new MAC address) 1. Power Supply 2. System Board 1. Diskette Drive 2. System Board 3. Diskette Drive Cable 1. System Board 2. Primary Hard Disk Drive 3. Hard Disk Drive Cable Incorrect memory size during POST 1. Run the Memory tests 2. Memory Module 3. System Board ″Insert a Diskette″ icon appears with a 1. System Board known-good diagnostics diskette in the first 2. Diskette Drive Cable 3.5-inch diskette drive. 3. Network Adapter Intensity or color varies from left to right of 1. Display characters and color bars 2. Video adapter (if present) 3. System Board No power or fan not running 1. See “Power Supply Problems” on page 55. Chapter 7. Symptom-to-FRU Index 81
- Page 35 and 36: 2 1 Chapter 2. Safety information 2
- Page 37 and 38: ATTENZIONE: Quando si sostituisce l
- Page 39 and 40: Chapter 2. Safety information 33
- Page 41 and 42: PELIGRO La corriente eléctrica pro
- Page 43 and 44: ≥18 kg ≥32 kg ≥55 kg PRECAUCI
- Page 45 and 46: Chapter 3. General information This
- Page 47 and 48: For all machine types Environment A
- Page 49 and 50: Chapter 4. General Checkout Problem
- Page 51 and 52: Chapter 5. Diagnostics PC-Doctor fo
- Page 53 and 54: 7. When prompted, insert a blank, f
- Page 55 and 56: The Full Erase Hard Drive provides
- Page 57 and 58: Chapter 6. Using the Setup Utility
- Page 59 and 60: 3. Select the desired startup devic
- Page 61 and 62: Chapter 7. Symptom-to-FRU Index Har
- Page 63 and 64: Diagnostic Error Code FRU/Action 00
- Page 65 and 66: Diagnostic Error Code FRU/Action 00
- Page 67 and 68: Diagnostic Error Code FRU/Action 00
- Page 69 and 70: Diagnostic Error Code FRU/Action 01
- Page 71 and 72: Diagnostic Error Code FRU/Action 01
- Page 73 and 74: Diagnostic Error Code FRU/Action 01
- Page 75 and 76: Diagnostic Error Code FRU/Action 02
- Page 77 and 78: Diagnostic Error Code FRU/Action 07
- Page 79 and 80: Diagnostic Error Code FRU/Action 08
- Page 81 and 82: Diagnostic Error Code FRU/Action 17
- Page 83 and 84: Diagnostic Error Code FRU/Action 30
- Page 85: POST error codes Each time you powe
- Page 89 and 90: c. Memory modules d. Extended video
- Page 91 and 92: Chapter 8. Replacing FRUs (Types 70
- Page 93 and 94: Computer components The following i
- Page 95 and 96: Removing the cover Important Read C
- Page 97 and 98: 4. Using the blue handle▌1▐, li
- Page 99 and 100: Replacing the CMOS battery If the C
- Page 101 and 102: 7. Lift the power supply out of the
- Page 103 and 104: 12. Lift the heat sink and fan asse
- Page 105 and 106: Replacing the microprocessor This p
- Page 107 and 108: Notes: a. Note the orientation of t
- Page 109 and 110: Replacing the hard disk drive Impor
- Page 111 and 112: Replacing an optical drive This pro
- Page 113 and 114: Replacing the power switch/LED asse
- Page 115 and 116: Replacing the system fan assembly T
- Page 117 and 118: Completing the FRU replacement Afte
- Page 119 and 120: Chapter 9. Replacing FRUs (Types 70
- Page 121 and 122: Computer components The following i
- Page 123 and 124: Removing the cover Important Read C
- Page 125 and 126: Replacing the power supply This pro
- Page 127 and 128: 11. Remove the four screws ▌1▐
- Page 129 and 130: 17. Lower the microprocessor straig
- Page 131 and 132: 5. Lift the heat sink and fan assem
- Page 133 and 134: 11. Lower the microprocessor straig
- Page 135 and 136: Replacing a PCI adapter This proced
80 Hardware Maintenance Manual<br />
POST Error Message Description/Action<br />
Press TAB to show POST screen Pressing the TAB key permits the user to<br />
toggle between the default POST display<br />
screen and a custom POST display screen.<br />
Error: Non-System disk or disk error<br />
Replace and press any key when ready<br />
The BIOS was unable to find a suitable boot<br />
device.<br />
Make sure the boot drive is properly<br />
connected to the computer.<br />
Make sure you have bootable media.