Technical Finishes Profile

TECHNICAL DATA SHEET
SOLIDBOND QSP
17 August 2016, Rev 2
SOLIDBOND QSP
Quick set paste adhesive
DESCRIPTION
Solidbond QSP is a solvent free, epoxy quick set epoxy adhesive for bonding ceramics, acid bricks,
steel or concrete. It may also be used for a wide range of adhesive applications where rapid set
and high chemical resistance is required.
Benefits:
Excellent chemical resistance – resists attack of petroleum products, acids and alkali.
Fast curing
Damp tolerant
Thixotropic and can be applied to vertical or overhead surfaces.
Good temperature resistance
Ease of application
Substrate requirements:
Surfaces to be treated must be free of dust, oily residues and loose friable material.
TECHNICAL DETAILS:
Appearance : Part A – Off white / Part B – brownish Physical Properties
Pot life : 15 - 20 minutes Service Temperature : wet 60 deg C : Dry 90 deg C
Set : 1 hour Tensile strength : > 50 Mpa
Mix ratio : 2:1 by volume Compressive strength : > 75 mpa
Full cure : 24 hours, cure is temp sensitive Bond strength ceramics > 11 Mpa
Application temperature : 5 - 35 ºC
Packaging
: 1.5 L kits
Health and safety: Epoxy products are to be treated with care. In the event of skin contact, was
well with soap and warm water. Seek medical assistance immediately in case of eye contact.
Please consult Health and Safety Data sheets for each product.
Technical Finishes products are guaranteed against defective materials and are manufactured
under high quality standards and are sold subject to its standard Terms and Conditions of Sale,
copies of which can be obtained on request.
Page 1 of 1
Gauteng Kwa-Zulu Natal Western Cape
35 Activia Rd, Activia Park, Germiston, 1610 41 Circuit Rd, Westmead 3610 Cnr. Gunners Circle & Fisher Ave, Epping 1,
7475
Tel: +27 (0) 11 822 7242 Tel: +27 (0) 31 705 7733 Tel: +27 (0) 21 535 4455