Miljövänlig , Låg Kostnad, Mindre Känd Vatten Teknik för Framtiden (Sammanfattning på Svenska) / Environmentally Friendly, Low Cost, Less Well Known Water Technology for The Future

• 35’Vacuum Flash Vaporization/Vacuum Distillation
Effect Accepted,or Rejected by Western Mainstream(WM)
• ■ 35’Low Pressure/Vacuum Flash Vaporization/Vacuum Distillation/Flash evaporation: Can be
linked to 34’Ice/Vacuum Freezing. Also widely used but rare stand alone or major use in:
• Accepted: K2(energy saving): Quick evaporation of heavy very fine spray Air Fogging,(Turbine
Inlet Air Cooling: TIAC) at high ambient temperature air intake for gas turbine or HVAC fan etc,
can cause sufficient cooling to increase air density to save 10%+ range energy use/production
cost even for large systems(Johnson Controls, Kiri no Ikeuchi, Araner+). Std process in advanced
nation's new system but under utilized in old systems.
• M2(desalination): Easily built in as part of very low heat recovery in existing factory/generator
station etc. Often private use or test operations: as low as 26-32°C:(Kerala/Karunya State
Council for Science, National Institute of Ocean Technology of Chennai, Passarell Desalination
+). At 45°C:(Inst. of Ocean Energy Saga+), Not on tech list but low cost high temperature vacuum
freezing is widely used - but not for freeze desalination. 、
P2(Wastewater cleaning): sometimes lowest cost solution: Vapor Compression Evaporation-
Distillation/Mechanical Vapor Recompression(MVR): low grade heat water goes through venturi/
orifice to made into steam partially at low temp, then that steam gets compressed to generate
heat(ie far more than COP>1: overunity) and this heat is used to raise liquid temperature itself to
enable efficient low cost recovery of water, also often uses vortex flow/hydrocyclone for efficient
solids separation(ENCON Evaporators, PureStream, Salttech DyVaR ZLD+),
linkedin.com/in/newnatureparadigm
- Ben Rusuisiak, Vancouver BC, Canada
209